Your cart is empty.
Your cart is empty.
Type 1 300psi regulator:
You must know the following tips to build your project:
1. Please connect all parts first, then close this adapter to connect the PaintbaII tank to expel CO2/air or start refilling.
2. When you are removing parts from a full air/CO2 tank or after refilling, please turn off the switch on the adapter, regulator or valve or unscrew this adapter to stop the air from venting before removing. Otherwise the air will be used up and dangerous.
3. Our 0-300 adjustable regulator with input pressure below 1000psi.
How this works:
To prevent the meter from exploding during installation, follow the instructions:
1. Turn the knob counterclockwise until the lever is fully released before venting, closing the regulator.
2. Then screw the regulator onto the HPA bottle.
3. After installation, the knob can be tightened clockwise to adjust the required pressure. But keep the pressure below 300psi or the gauge will burst.
Type 2 0-1500PSI Regulator:
You must know the following tips to build your project:
1. Please connect all parts first, then close this adapter to connect the PaintbaII tank to expel CO2/air or start refilling.
2. When you are removing parts from a full air/CO2 tank or after refilling, please turn off the switch on the adapter, regulator or valve or unscrew this adapter to stop the air from venting before removing. Otherwise the air will be used up and dangerous.
3. Our 0-1500psi adjustable regulator with input pressure below 1000psi.
How this works:
To prevent the meter from exploding during installation, follow the instructions:
1. Turn the knob counterclockwise until the lever is fully released before venting, closing the regulator.
2. Then screw the regulator onto the HPA bottle.
3. After installation, the knob can be tightened clockwise to adjust the required pressure. But keep the pressure below 1000psi or the gauge will burst.
Type 3 0-2800PSI Regulator:
Output thread: G1/2-14
Input thread: 0.825-14NGO
Input pressure: 3000psi
Output pressure: 0-2800psi
Pressure gauge range 0-5000psi
You must know the following tips to build your project:
1. Please connect all parts first, then close this adapter to connect the PaintbaII tank to expel CO2/air or start refilling.
2. When you are removing parts from a full air/CO2 tank or after refilling, please turn off the switch on the adapter, regulator or valve or unscrew this adapter to stop the air from venting before removing. Otherwise the air will be used up and dangerous.
3. Our 0-5000psi adjustable regulator with input pressure below 3000psi.
Package Included:
1 * Regulator
