Your cart is empty.
Your cart is empty. Features:
1. This Board can storage charge and discharge 1S LiPo LiHv batteries ,used with lipo balance standard charger.
2. Easy to use,Turn the knob to the number of batteries you want to charge.
3. Charge 1-6 1S lipo LiHv batteries at the same time.
4. Added Max 3 amps of PTC fuse(Positive Temperature Coefficient) for safer charging.
5. Applicable for PH2.0 and BT2.0 connector battery.
6. High quality knob and low resistance（less than 0.05 Ohm） for long uselife.
Use steps:
First ,turn the knob to the right position according to the battery quantity you will charge,
then plug in the batteries into the connector marked“1S-2S-3S…”,finally connect the series board to the charger with cables.
Example: You have 4pcs 1s Lipo or Lihv batteries to charge, first turn the knob to “4S” position, then plug the batteries into the ports 1S, 2S,3S and 4S in turn ,
then connect the board to the charger with the balance cable and XT60 cable.
There you can start your charging.
Tips:
1. It is the series board not parallel board. For example, when you are charging 3pcs 500mAh lipo, set your charger to 0.5A for 1C or 1A for 2C. NOT 1.5A or 3A.
2. Do not charge over 3 amps. The safty PTC fuse is 3A for max charging current.But even you made the mistake to charge more than 3A current,
The fuse will be self-recovery after open circuit for a while(over loading).So you can use the board again.
3. All batteries should be the same capacity, battery type and brand, etc.
4. Don't plug in both PH2.0 and BT2.0 battery at the same time.
5. Never leave the board unattended while using it.
Max charging current : 3.0A
Dimensions : 100*50*50mm
Battery connector type : PH2.0 & BT2.0.
Weight :55g
Package:
1* 1S series charge board
1* Banana plug to XT60 male silicone cable
Bullphourg
Reviewed in the United States on February 9, 2025
OK for the price. It is the only way I can figure out how to put 1s batteries in storage mode. Do not leave the batteries plug in as it will drain them to a level below which many chargers are able to detect. It will make batteries unchangeable if the charge level goes to low unless you have a way to force charge the battery.
G Kennedy
Reviewed in the United States on July 28, 2023
Works as advertised. Charges all of my 1s battery's at once.
Nonsense
Reviewed in the United States on May 17, 2023
Solid built adapterTurns my (6) 1s 500mah into 1 big 6s 500mah they can all charge , balance, or storage in 15 minutes.Massive time saver!
Recommended Products
