Your cart is empty.
Your cart is empty.Dorman's Window Regulators have been re-engineered to improve on the original design. The latest technological advances in motors, materials and cable systems have been applied to new and previously released applications.
Teresa
Reviewed in Canada on September 9, 2020
as the garage says on amazon it fits my vehicle. It did and works great!
Abird
Reviewed in the United States on January 23, 2017
Worked super great. Old part broke on my 2007 Hyundai Elantra and this part fit perfectly and has worked great ever since!
BC
Reviewed in the United States on July 15, 2016
GREAT fit Works great
Jordan
Reviewed in the United States on March 12, 2015
I purchased this part but was actually the wrong one for my car. It comes pre greased but in my case, the black plastic arm was slightly broken right out of the package.
William L. Hanna
Reviewed in the United States on January 3, 2015
Did not work for my application
Big Al
Reviewed in the United States on September 29, 2014
It fits and works perfectly. It even has the Hyundai logo stamped into it.The one caution is the edges around the access ports to the window bolts are razor sharp. I ended up putting tape over them.The window glass merely slides into the rubber lined clamps so leave the bolts alone. Drop down window, make sure it's level and tighten the two bolts. When you insert the new regulator panel, insert the outer edge where the black fingers are first, then slide in, align bolt holes, and re-assemble.Re: the car, I couldn't figure out how to unplug the power door actuator so I (oops) cut thru the metal to free the wire loom on both the old and new one.Also the car, the door speaker was pop riveted in. I have a pop riveter but if you don't have a riveter, you can use thin screws and nuts.
Recommended Products
