Shopping Cart

Your cart is empty.

Your cart is empty.

Gas Fuel Tank Cap w/Chain & Filter For OEM Honda GX390 GX270 GX160 Engine 17620-Z4H-030, Genuine Gas Lid For Generac Pressure Washer 17620-Z4H-900

Free shipping on orders over $29.99

$60.09

$ 27 .35 $27.35

In Stock

About this item

  • 🏍 OEM Genuine Gas Lid For Honda Motors Accessories GX340 GX390 152F 168F 188F 190F 170F0 154F 152F 168F 188F190F 170F0 154F GX120 GX160 GX200 GX240 GX270
  • 🏍 Glory Chrome & Largest Gas Cap to Modify Original Tiny one from Factory & Ensure Firm Grip in any case;
  • 🏍 High-strength springs inside to fit and seal fuel tank; Special leakage proof;Reliable Vent hole was designed to ensure sufficient fuel supply.
  • 🏍 Extra chain to provent from gas cap losing, Also come w/ a new fuel filter for a rapid change.
  • 🏍 Upgraded Cap Structure designed, New Raised Metal Cap End Firmly Seal & Fill up the empty Space above the fuel filter, keep fuel remain and sealed in tank.
  • 🏍 Cap width: 85mm; Cap Top Height:26mm; Cap inside width from tab to tab: 47.5mm; Cylinder diameter: 38mm
  • 🏍 Made of Stainless steel with Solid thick rubber gasket inside.


Genuine oem gas cap lid for honda gx390 gx340 gx270 gx240 gx200 gx160 engine


George E Foley
Reviewed in the United States on June 22, 2024
Replaced bad gas lid, was too sloppy. This one fit tight.
DSK
Reviewed in the United States on September 12, 2023
I bought this for my Honda GX200 engine. This JMCHstore Gas Fuel Tank Cap is not designed for my engine. I messed up and ordered the wrong one. I will say that the JMCHstore Gas Fuel Tank Cap look like good quality and will order the correct size from them.
AR
Reviewed in the United States on August 9, 2023
This was to replace a generator gas cap on a pressure washer that is near 15-20 years old. It makes the pressure washer look only 5 years old. The cap is very well made and an upgrade over the OEM cap, which is why it is more expensive than others. The fuel filter fits nicely into the metal sleeve and everything is well made. What did not go well is the chain attached to the cap. I could not get it to rest properly so the cap would close properly. After several attempts, the chain broke. Once removed, the cap and filter worked great and I'm not really worried about the gas cap disappearing anyway... It is hard not to notice. This is a well made cap that should last a very long time.
Recommended Products