Your cart is empty.
Your cart is empty. Insert into ∅5/8 for fast hold-down clamping.
Mount on the Right Angle Bracket, Riser Block, or Clamping Squares for push down clamping at an elevated height for taller workpieces.
The patented rear crank handle allows clamp pressure adjustment while the clamp is in locked position. Use the crank handle to pre-set the clamp opening in repetitious clamping applications.
Customer
Reviewed in the United States on February 27, 2025
GOOD PRODUCT QUICK DELIVERY WOULD USE AGAIN
M. S. Thomasson
Reviewed in the United States on September 6, 2024
Anybody thats ever used a vise grip will be disappointed...wimpy is being generous. Sending them back, not for me.
Terry
Reviewed in the United States on September 11, 2024
I had to ream out the holes some but they work fine.
Customer
Reviewed in the United States on December 27, 2024
These work but they're canted to one side, I'll buy something different next time.
Kyle Jensen
Reviewed in Canada on April 11, 2024
I don't think I own a pair of clamps as skinny as the this clamp, make sure you are only clamping down something light a strong breeze could probably bend these they are skinner than a sharpie
Opie
Reviewed in Canada on July 9, 2023
Super small. Or my hands may be abnormally big. Highly recommend but be warned to double a check size being purchased.
John Mann
Reviewed in Canada on July 15, 2023
Great for clamping odd shaped material on a drill press.
GeooeG
Reviewed in the United States on August 23, 2022
I bought a welding table a few years ago with 16mm holes. It came with clamps that had to be secured with a nut on the bottom and that was a serious pain to use when you wanted to make some quick changes to a layout before welding. I had been hesitant to order one of these because they are sized for 5/8 holes and was worried that the very slightly larger 16mm hole would make them sloppy. Turns out, they work just fine. The crank handle is easy to turn and the swivel pad makes good contact with flat stock. It is so fast to use, just push into a hole on the table, line it up and clamp. Way better than fumbling under the table with a nut. I bought one, then after using it once, bought another one. I will likely order some of the larger ones when I run into a project that needs a bigger reach.
Murray Knudson
Reviewed in Canada on November 2, 2022
Light duty only
Kyle Quinn
Reviewed in Canada on January 19, 2021
They are tiny. They work but so tiny
Recommended Products
