Your cart is empty.
Your cart is empty.IVY Classic 3-5/8" Slotted Sidewalk Driver allows drills or impact drivers to drive sidewalk bolts for installation of hurricane shutters. Made of Chrome Vanadium Steel for extra strength and durability, they are designed to withstand the high torque (rotational force) of impact drivers. IVY Classic's Industries is dedicated to producing a comprehensive, quality line of power tool accessories and hand tools.
jennifer oles
Reviewed in the United States on January 17, 2025
This bit fits great on my hurricane shutters bolts and eliminated stripping the bolts.
Tucker C
Reviewed in Canada on February 29, 2024
The cover does not stay held back from the screwdriver a bit because it’s spring loaded so if you’re in a tight space, you’re trying to drive the bit and also hold back the cover at the same time
Fran
Reviewed in the United States on November 6, 2024
works as it should
Edward Davis
Reviewed in the United States on July 17, 2023
This was purchased to assist in removing/ loosening hurricane screws to install hurricane shutters. The flat head works great even on those screws that the house painters have put many coats of paint on. Tightening is just as easy..
Customer
Reviewed in the United States on May 26, 2023
I used this tool to finish installing a security screen door, held in place with one-way screws. The tool supplied by the door manufacturer was flimsy, and didn't even install 1/3 of the bolts. Considering my experience with the supplied tool, I bought two of these, just in case. The first one did the job well, showing no damage to it, after I was done..
Kansas Coast
Reviewed in the United States on February 12, 2023
I couldn't find a tool to drive the security screws that came with the Grisham mounts into my window frame. The heads of the screws are similar to those found here on Amazon that are made by the Hillman Group 230373 Heat-Treated One-Way Lag Screw 5/16" x 4". There's a large gap between sides of the screws, which the bar of this tool fit. The cover is spring loaded so even though the diameter of the screw head was slightly larger - I just had to put enough pressure on the head the get the screws to go in. I used a right angle adapter in my hammer drill. It wasn't a smooth process but I managed to get all four screws seated to mount the window guard. The screws I had were painted white - so afterwards I touched up the paint where the tools sometimes slipped and removed paint from the heads of the screws. The biggest issue I had was that this tool would sometimes slip out of the right angle adapter - and I'd have to put it in again. If you're just driving security screws in without anything getting in the way then the tool you work exceptionally well just inserted directly into your hammer drill. Hope this is helpful for someone trying to find a tool to use for a security screw or lag bolt.
Eric
Reviewed in Canada on December 5, 2020
I needed a big *ss flathead bit to remove a stuck plug on a boat rudder and it did a great job where everything else failed previously.
Recommended Products
$182.16
$ 71 .28 $71.28