Your cart is empty.
Your cart is empty.This is a stamped anodized aluminum bilge pump switch. Two means of alarm (visual and sound) are activated when water level in your bilge is beyond your bilge pump float switch level. Operation manual: See picture attached to this listing with drawings and instructions. Measurements: 2.5" by 3.25" installation: A float switch should be mounted approximately 8 inches above the existing float switch that operates that bilge pump. A two strand electrical cable should be then ran from the second float switch to the location on the bilge water alarm panel. See picture 5. Item: P10297.
ken
July 28, 2025
is what i expected
Warhouse
June 21, 2025
First time purchase of Pactrade Marine products. Intended use for West Coast off-shore saltwater fishing boat. Very pleased with item quality out of the box. The alarm screech is awesome! Hoping It never engages off-shore!!!Perfect replacement for Rule bilge alarm--paid $40 and crapped out after only 2 years.
Crazpony
June 16, 2025
Arrived quickly and had good installation instructions
Christine M Anderson
May 24, 2025
Easy to install, audio alarm has good volume, good looking, I purchased three mounted them vertically to serve 3 watertight compartments
Kenny Payne
February 16, 2025
The wires came off while I was installing it. Had to rewire it.
DougD
December 15, 2024
Have to do a little creative wireing, but works.
Recommended Products
$126.72
$ 50 .39 $50.39